Beisler 2111-4 - Manual (Page 68)

Short Seam Automat 2110-4 / 2111-4 Workinging Instructions
- D 68 -
Beisler Automated Sewing Equipment
D.3.1 System menu
Running clamp motor in permanent test:
The clamp motor can be run permanently to check for
constant machine movement.
• Press
key.
• Press key (diagnostics).
• Press
key (clamp transport).
• Press
key (clamp motor permanent test).
Confirm safety prompt.
Press
% key.
The clamp motor runs permanently until it is stopped. To
stop the motor:
• Press program stop switch and unlock switch.
Testing the thread cutter:
By entering a three-digit value global parameter 35, you
can determine when the thread cutter is activated. The
input must be checked for a machine cycle and corrected
if required.
• Press
key.
• Press
key (diagnostics).
• Press
key (sewing motor).
• Press
key (thread cutter).
• Enter value using numeric keypad.
Start or stop machine cycle.
• Press
key.
D.3 Programming
D.3.1 System menu
Copying variables to the memory card:
All variables (global parameters/special parameters) can
be stored on the memory card (backup copies).
• Insert memory card into slot until stop.
• Press
key.
• Press
key (memory card).
• Press key (all variables --> card).
Confirm safety prompt.
• Press % key.
Loading variables from the memory card:
All variables (global parameters/special parameters) can
be downloaded from the memory card to the program con-
trol memory to reestablish the machine configuration.
• Insert memory card into slot until stop.
• Press
key.
• Press key (memory card).
• Press key (card --> all variables).
Confirm safety prompt.
• Press % key.
NOTE - Current configuration!
If this function is used to download all variables from the
memory card to the program control, all current sewing
programs will be overwritten.