Aviosys 9212 Delux - Manual (Page 7)

- 6 -
3. Interface Description
I P Power 9212 has three units, 9200 is the network module (base), the picture below shows
the three units of the IP Power 9212 :
9201 Input is the input /sensor module and 9202 Output is the output / control module
4. Hardware & Software installation
Before you star using the IP Power 9212, please follow the steps below:
 Check the package to make sure the contents are complete.
 Prepare one Ethernet HUB, or Router
 Check the voltage of the power supply to make sure it is AC 110-240 volt
Hardware Installation: Connect RJ45 first (before connect POWER jack)
1 Connect the 9200 to HUB through RJ 45 netting cable.
2 Connect the 9200 ( IN-BLACK ) to 9201( BLACK port) &
9200 ( OUT- BLUE ) to 9202 Output ( BLUE) through D-SUB
cable.
3 Connect the HUB to the Internet (May through ADSL/XDSL modem).
4 Connect the power adapter to the 9200.
Power on your computer and power adapter of IP POWER 9212.