beautypg.com

Connecting the power cable, Checking the alignment, Connecting the power cable -4 – Avery Dennison Monarch 928 Stacker User Manual

Page 8: Checking the alignment -4

background image

1-4 Operating Instructions

C o n n e c t i n g t h e P o w e r C a b l e

To connect the power cable:

1. Turn off the printer. Make sure the stacker’s power switch is turned off.

2. Make sure the stacker is properly aligned with the knife. See “

Installing

the Stacker

for more information.

3. Plug the power cable into the socket.

4. Plug the other end of the cable into a grounded electrical outlet. Once the

power cord is attached to an outlet, the stacker is on. There is no power
ON/OFF switch.

5. Turn on the printer. Press (I) to turn on and (O) to turn off the stacker and

printer.

C h e c k i n g t h e A l i g n m e n t

The stacker must be flat on a level surface. To check the alignment of the
stacker:

1. Turn on the printer.

2. Print a batch of tags and check for nicked corners. Refer to your printer’s

Operator’s Handbook for instructions.

Note:

Nicked corners may occur on four-inch wide tags.

3. To adjust the stacker’s alignment, push the stacker slightly forward or

backward along the mounting plate.

4. Print another batch of tags and realign if necessary.

5. Make sure the stacker’s feet are flat on a level surface. You can raise or

lower the feet by turning them. Turn the nut to lock the feet in place.

You are now ready to print tags and make adjustments to the stacker. See
Chapter 2,

Operation and Adjustments

”, for more information.