Avery Dennison Monarch 928 Stacker - Manual (Page 23)

T R O U B L E S H O O T I N G 3
This section helps you correct some problems that may occur.
Problem Action
Stacker Full Empty the tray. Press Clear to clear the
error and resume printing.
The stacker may not be plugged into an
outlet. Verify the power connection.
Stacker Jam Clear the jam. Press Clear to clear the
error and resume printing.
If the jam is not inside the stacker, check
inside the knife or printer.
Stacker does not work. Make sure the stacker is plugged into an
outlet and is fully connected to the
printer.
Tags are stacked loosely. Empty the tray. Turn the adjustment knob
to a lower setting.
Adjust the guide rails and tag stop to the
width and length of the tags.
Tags are stacked too tightly. Empty the tray. Turn the adjustment knob
to a higher setting.
Troubleshooting 3-1