Avery Dennison Monarch 928 Stacker - Manual (Page 10)

5. Push the knife toward the printer until the knife does not pivot or rotate.
3. Use the tab to lift the transport and see where the tags are inside the
stacker. If the tags are too close to either wall of the stacker, adjust the
knife
alignment.
The supply is centered inside the printer but it may drift when it enters the
knife and the stacker. Sliding the knife to the left or right corrects the
alignment.
6. Slide the knife to the left or right to center the tags inside the stacker.
8. Feed another batch of tags through the knife and repeat steps 1-8 if
necessary.
4. Loosen the three thumbscrews connecting the knife to the printer.
L i f t
H e re
T a g s t o o cl o se t o
w all o f st a cke r
7. Tighten the three thumbscrews.
1-6 Operating Instructions