Avery Dennison Monarch 928 Stacker - Manual (Page 19)

Operation and Adjustments 2-9
L o a d i n g S u p p l i e s
If you run out of supplies while printing, the printer shows 756 on the
display.
1. Press Feed to feed the last tag into the stacker.
2. Load a new roll of supplies. Refer to the printer’s Operator’s Handbook
for instructions.
Note: If you are switching to a different supply, you need to reset the belt
movement. See “
Setting the Belt Movement .”
3. Press Clear to clear the error.
4. Press Feed (once or several times, depending on the tag’s length) to feed
a tag through the knife and into the stacker.
5. Print a batch of tags.
E m p t y i n g t h e S t a c k e r
You can empty the stacker while it is running, or wait until it is full.
Stacker Running
For continuous operation, empty the stacker tray before it is full.
When the tray is about half full:
1. Pick up some of the tags in front of the tag weight.
Note: If you have batch separators, keep all the tags in each batch
together.
2. Move the tag weight lightly against the stack. Do not push or compress
the stack.
3. Continue to remove tags as the tray reaches half full.