Avery Dennison RFID - Manual (Page 40)

HowToRFID
Revision: 13 Date: 31 August 2009
Page 40 of 53
#SIr/ n/h#G
n = int number of bytes to respond
#SIr/n/ h#G
h = string header used as prefix of data to respond
For details see [A0164].
5.3.5.2 #VW/I – Sending data to the host
Use the #VW/I/ command. For details see [A0164].
5.3.5.3 #RFC – Special RFID commands
Definition Sends a command sequence to the RFID reader module to trigger special operations
which are not mapped / part of the regular read/write/lock operations.
The commands are specific for a RFID reader module.
Command must be placed between #ER and #Q!
Syntax #RFC#G RFID printer
#RFC#G
= int Command code
--- HF Technology / FEIG reader ---
(*1) EAS features
16
set EAS bit
17 reset / clear EAS bit
18 lock EAS bit permanently
(*1) EAS features only supported by NXP I-Code chips
5.3.5.4 #RFL – Write protect (Lock) and unprotect (Unlock) memory areas
Definition
Activate or disable the write protection (simple lock) of various memory areas of EPC Gen
2 tags. Before changing the write protection status first the access password must have
once been written into to access password memory of the tag with a write command
(#RFW or #SRF + #VW/T). For any attempt to change to protection status the same
password must be provided as part of the #RFL command.
Please note: the #RFL command itself doesn’t write to access password into to tag!
The #RFL command doesn’t support the permalock option specified in the EPC Gen 2