Avery Dennison 6037 Rev.AC 9/03 - Manual (Page 16)

4-2 International Configurations
3. Flash the printer with the disk image.
4. Reboot the printer.
To switch temporarily from an international map to the default
map, press Alt and Fct at the same time, then 1. To switch
back, press Alt and Fct at the same time, then 2.
G e n e r a t i n g I n t e r n a t i o n a l C h a r a c t e r s
Tell your application’s end users to use the following keypad
maps (as applicable) to generate international characters.
In each map diagram, a square represents a key on the keypad.
Three characters are shown in each square, illustrating the
keystrokes necessary to enter the character, as follows.
À
A à
Press Shift + the key to get this
character
Press the key to get this character
Character from
the Default Map