Avery Dennison LOKPRINT II - Manual (Page 8)

8 •••• Location / Power Requirements Users Manual LOKPRINT™ II
Location / Power Requirements
Location of LOKPRINT™ II System
Recommended Work Station Layout.
The LOKPRINT™ II requires a workstation with a minimum worktable of 30”
(76.2cm) deep x 96” (243.8cm) long x 30” high (adjustable height may be desired
depending on if the operator will be standing or seating). The worktable does not
include a space for the computer. The table must be capable of supporting 300 Lbs.
(136.1Kg).
The LOKPRINT™ II should be installed with the alignment template included to
ensure the fabric tracks properly from the printer into the LOKPRINT™ II. Locate
the Finishing Station or Cold Knife Cutter as close to the exit of the LOKPRINT™ II
as possible without restricting its dancer arm travel.
AC Power Line
The LOKPRINT™ II requires an electrical service of 20A @ 115V or 10A @ 230V
and must be purchased as a 115 or 230 volt electrical configuration. Check the
machine’s serial number plate to make sure the machine is the desired electrical line
voltage. Power consumption is 18 amps @ 115 volts and 9 amps @ 230 volt.
Connect the power cord to a grounded 115 or 230 volt AC electric outlet of sufficient