Avery Dennison LOKPRINT II - Manual (Page 13)

Users Manual LOKPRINT™ II LOKPRINT™ II Assembly •••• 13
13) Once the oven position has been checked / adjusted - run the system and take
note of the fabric position in relation to the oven as it enters the oven. Adjust the
Lokprint II box forward or backwards on the bench in relation to the printer
using the template / mount knob. The web position collars on the 676 are more
for a reference then position. Do not use them to deflect the web, as wrinkling
will occur. Do set them to the web edges after the Lokprint II position has been
adjusted to cause the fabric to flow into the oven centered front to back.
14) Once the Lokprint II position has been checked / adjusted - run the system and
adjust the Finishing Station on the bench forward or backwards in relation to the
Lokprint II box so that the fabric flows straight into the Finishing Station’s web
guides.
15) Using the CALIBRATION PROCEDURE section of IS 561301 Rev 2 or higher
check / adjust U1 and U2 offsets as needed to produce and monitor the exit
temperature at 400° while running stabilized.
Note: Requires AVERY DENNISON Service
16) Using the SP2 ADJUSTMENT PROCEDURE section of IS 561301 Rev 2 or
higher check / adjust U1 SP2 as needed to transition from idle to running without
deforming the fabric or dipping in process temperature.
Note: Requires AVERY DENNISON Service
System Interface Cable Connections
Connect both the 7 and 15 pin cable connectors located on the left side of the
LOKPRINT™ II to the host printer. Connect the 7-pin cable connector located on
the Finishing Station or Cold Knife to the 7-pin receptacle located on the right side of
the LOKPRINT™ II.
Installing the Power Cord
Both the 115V and 230V machines incorporate a quick disconnect power cord. The
115V cord requires a NEMA 5-20R receptacle while the 230V cord requires a
NEMA 6-15R receptacle. Install the receptacle end of the power cord in the plug on
the back of the machine then insert the plug end of the cord in the appropriate wall
outlet.