Avery Dennison LOKPRINT II - Manual (Page 19)

Users Manual LOKPRINT™ II LOKPRINT™ II Operation / Adjustments •••• 19
INCORRECT
WEB TENSION CORRECT WEB
TENSION
Heat Chamber Care
In the unlikely event that the fabric touches the bulbs - it will melt onto them and / or
the inner oven. Remove as many of the un-melted pieces as possible without
touching the bulbs.
DO NOT attempt to scrape melted fabric from the bulbs. Any remaining fabric
residue will burn off, much like a self-cleaning oven. Simply re-thread
a fresh section of fabric and continue printing.
CAUTION: DO NOT try to scrape or chip melted fabric off the IR lamps. This
could permanently damage the IR lamp. You will notice an increased
amount of smoke in the heat chamber as the bulbs burn off the melted
web fabric. This is normal.
Feed Roller Care
The feed rollers will pick up the ink dye during normal operation. The rollers should
be cleaned after every two rolls of ink. The rollers can be cleaned with alcohol and a
nylon bristle toothbrush. The rollers have a Teflon® coating that can be damaged if
cleaned with a wire brush, making it very difficult to clean once the coating is worn
off. The alcohol used for cleaning should have an alcohol content of 70% or higher
and can be purchased from your local drug store.