Avery Dennison LOKPRINT II - Manual (Page 18)

18 •••• LOKPRINT™ II Operation / Adjustments Users Manual LOKPRINT™ II
Feed Roller
The feed roller has two torsion springs that supply even tension for tracking. If the
fabric fails to track properly through printer, check to see if one of the springs have
come loose, broken or been stretched out of shape. The feed is equipped with a hand
knob used to thread the machine. This knob should turn freely with very little
resistance. If resistance occurs, check to see if the roller bearings need to be greased
/ replaced. Use standard multi purpose grease to lubricate the bearings. To lubricate
the bearings - the assembly will need to be disassembled, cleaned and repacked with
grease. Do not use contact cleaners to clean the bearings, as this will destroy the
needle bearings.
Web Threading
Feed the fabric through the AVERY DENNISON 676 or 636 printer (see the
AVERY DENNISON 676 or 636 manual for threading instructions), then through the
LOKPRINT™ II and on through the Finishing Station or Cold Knife Cutter. Tension
the web with the feed knob to remove excess slack between the printer feed rollers
and the LOKPRINT™ II feed rollers. The system will further tension the web at the
start of printing, but may not take out excessive web sag.
TENSION WEB ROTATE
AVERY DENNISON LOKPRINT™ II