Avery Dennison LOKPRINT II - Manual (Page 5)

Users Manual LOKPRINT™ II Scope •••• 5
Scope
Introduction
This user manual was arranged for the person who is going to operate the system.
The information is arranged in the order that is needed to install, and then operate the
system. It starts with general information, then to unpacking the carton, setup,
installing the supplies, machine operation, and then finally care and maintenance.
We at AVERY DENNISON hope that you will come to appreciate the efforts and
quality that have gone into producing your AVERY DENNISON LOKPRINT™ II
System and wish to remind you that you are our number one priority. We welcome
any constructive comments or criticisms so that we may continue to offer you the best
products in the industry for years to come.
Safety Issues / Warnings
Caution
This system has some pinch points and hot surfaces. All of these areas have been
well guarded and it is recommended that the safety features of this system are never
altered or defeated.
Heaters
The heat chamber has been designed to prevent the operator from coming into
contact with areas that will cause burns during normal operation. Some surfaces are
very warm to the touch. The IR lamps and internal lamp guards are extremely hot.
Extra care should be taken when threading the machine while the machine is turned
on. Any maintenance or cleaning should be done after the machine has been turned
off and allowed to cool.
Feed Roller
The feed rollers will absorb heat from the web as the machine runs. These rollers
have a self-closing cover to avoid contact during operation. The feed system is also
equipped with an operator knob to advance the fabric forward and backwards as
needed to avoid touching the hot rollers.
CAUTION: TURN OFF THE POWER AND ALLOW THE MACHINE TO COOL
BEFORE CLEANING.