Avery Dennison Monarch 9416 XL Printer Equipment Manual - Manual (Page 17)

7. Turn the dial to adjust the internal supply guides to their widest position.
8. Feed the fan-fold labels through the supply guides, over the supply holder and
over the platen roller.
Dial
Supply Guides
9. Press the fan-fold labels under the supply
guides.
10. Turn the dial to move the supply guides so that
they barely touch the edges of the supply.
11. Close the cover until it locks in place.
12. Press the FEED button. The indicator light
should be GREEN.
13. Calibrate the supply, if necessary. See
“ Calibrating the Supply ,” for more information.
C a l i b r a t i n g t h e S u p p l y
1. Turn off the printer.
2. Press and hold the FEED button while turning on the printer.
3. Release the FEED button after the indicator light starts flashing ORANGE. The
printer calibrates the black mark or die cut sensor, measures the label length, and
prints the test labels.
4. To resume normal printing, turn off the printer, wait two seconds, then turn it back
on again.
Loading Supplies & Printing 2-9