Avery Dennison Monarch 9416 XL Printer Equipment Manual User Manual

Page 14

4. Remove the supply holder guide from one end of the supply holder. (The supply

holder is normally attached with a line to the inside of the printer, not free-
standing as shown below. Do not cut the line.)

5. Slide a roll of labels onto the supply holder.

Note: If the core diameter on your roll of labels is 1-inch in diameter, remove the

1.5-inch supply core adapters from the supply holder guides.

6. Slide the supply holder guide back onto the end of the supply holder. If you are

using the supply core adapters for 1.5-inch core supply, make sure to push the
supply core adapters into the ends of the supply.

7. Insert the ends of the supply holder into the slots in the supply roll mount.

Supply Holder

1.5-inch Supply
Core Adapter

Supply Holder Guides

Dial

Supply Roll Mount

2-6 Equipment Manual