Loading supply for non-peel mode, Loading supply for non-peel mode -2 – Avery Dennison Monarch 9416 XL Printer Equipment Manual User Manual

Page 10

L o a d i n g S u p p l y f o r N o n - P e e l M o d e

The printer can print on thermal-direct labels and tags. Make sure the black mark/die
cut sensor is set correctly for your supply type. See “

,” for more information.

Note: If you run out of supply while printing, do not turn off the printer when

reloading the supply. You may lose your data. The printer resumes printing
when reloaded.

1. Remove and discard the tape from a new roll of supply.

2. Press the cover release levers (located on both sides of the printer) towards the

front of the printer to release the cover.

3. Lift open the cover.

4. Remove the supply holder guide from one end of the supply holder. (The supply

holder is normally attached with a line to the inside of the printer, not free-
standing as shown below. Do not cut the line.)

1.5-inch Supply
Core Adapter

Supply Holder

Supply Holder Guides

2-2 Equipment Manual