Avery Dennison Monarch 9416 XL Printer Equipment Manual - Manual (Page 16)

14. Push the peel door closed until it locks.
15. Close the cover until it locks in place.
16. Press the FEED button. A label separates
from the backing paper. Remove the peeled
label and another label prints.
Note: Hold the leading edge of peeled labels
when printing on supply longer than six
inches.
17. Calibrate the supply, if necessary. See
“ Calibrating the Supply ,” for more
information.
L o a d i n g F a n - F o l d S u p p l i e s
1. Place a stack of fan-fold supplies behind the printer, label side up.
Note: You may have to move the printer to allow room for the supply.
2. Push the external supply guides (located on the back of the printer) out to their
widest position.
External Supply
Guides
3. Feed the fan-fold labels, printing side up, into the external supply slot on the back
of the printer and through the external supply guides.
4. Adjust the external supply guides so that they barely touch the edge of the supply.
5. Press the cover release levers (located on each side of the printer) towards the
front of the printer to release the cover.
6. Lift open the cover. Leave the supply holder in the printer.
2-8 Equipment Manual