Argox F1 - Manual (Page 64)

64
Troubleshooting
This section provides information about errors that you might need to
troubleshoot. If an error condition exists with the printer, review the LCD
display error messages below for possible causes and the solutions.
Error Messages
LCD Display Blinking
LED
Buzzer
alert
Possible Cause Solution
HEAD OPEN ALERT YES The print head is not
fully closed.
Close print head
completely.
RIBBON
OUT
ALERT YES Ribbon is not loaded or
is incorrectly loaded.
Load ribbon correctly.
MEDIA OUT ALERT YES Media is not loaded or is
loaded incorrectly.
Load media correctly.
MEMORY
FULL
ALERT YES Memory is full. Delete data in the
memory or expand
the memory.
CUTTER
FAILED
ALERT YES Media is jammed in the
cutter.
Remove the jammed
paper.
SERIAL IO
ERROR
ALERT YES Format or baud rate of
RS232 communication
is inconsistent between
printer and host.
Check the baud rate,
format or protocol
between host and
printer.
HEAD TOO
HOT
ALERT YES The temperature of the
print head is too hot.
Let the printer cool
down. Printing will
resume when the
print head cools to a
suitable temperature.
PAUSE ALERT NO The printer is paused. Press the CANCEL
button once to
resume.