Argox F1 - Manual (Page 50)

50
Select or Adjust the Media Sensor
This printer uses two types of media sensors: See-through and reflective.
The default is see-through sensor No 1.
Select the See-through Sensor
The standard see-through sensor is in a fixed position and enabled from the
control panel. (Figure 23)
Figure 23
Adjust the Reflective Sensor
1. Press down the Thermal Print Head (TPH) release lever to release the print
head module.
2. Lift the print head module to expose the media sensor cover. (Figure 24)
3. Slide the media sensor until the reflective sensor aligns with the gap or
notch . (Figure 25)
Figure 24 Figure 25