Argox F1 - Manual (Page 13)

13
Placing the Printer
Before setting up and connecting the printer, please consider the following:
 Find a solid surface that is large and sturdy enough to accommodate the
printer. Choices could include a table, countertop, desk, or cart.
 This printer is designed to function in a wide range of environmental and
electrical conditions. Please make sure to clear the ground and isolate the
power adapter from other electrical cables.
 Isolate the power cord from other electrical cables.
Warning！ Do not operate the printer in an area where it might get wet.
Connecting the Printer to a Power Source
Connect the printer to a power source, as follows:
1. Make sure the power switch is in the off (O) position.
2. Plug one end of the power cord into the power jack on the back of the
printer, and the other end of the cord into an AC electrical outlet.
3. Turn on (I) the printer.
Power Switch