Argox F1 - Manual (Page 63)

63
Maintenance
Argox recommends using following material to clean the printer:
 100% ethanol
 Cotton swab
 Blower brush
CAUTION!
1. The print head gets hot and could cause severe burns. Always allow the
print head to cool before maintenance.
2. Argox is not responsible for damage caused by the use of cleaning fluids
on this printer.
Component Procedure Frequency
Print head 1. Open the print head and
remove the media and
ribbon.
2. Using the swab and 100%
ethanol, wipe the print
head from end to end.
Clean the print head
after each change of
ribbon.
Platen roller Manually rotating the platen
roller, clean it thoroughly with
100% ethanol and swab.
Clean the platen roller
when changing a new
label roll.
Tear-off/Peel-off bar Use the swab to remove
excess adhesive from the
tear-off/peel-off bar.
Once a month.
Sensor Air blow or vacuum. Once every six
months.