Argox F1 - Manual (Page 53)

53
Password Parameters
The F-Series printer has three password levels. When you enter the setup
mode on the control panel, parameters which are not protected by password
are displayed. You must enter a correct password to enter AUTHORISED
SETUP 1 and AUTHORISED SETUP 2. The password levels and default
passwords are shown in the following table.
Password Level Level name Default Password
3 AUTHORISED SETUP 2 9999
2 AUTHORISED SETUP 1 1234
1 BASIC SETUP No password
To enter a password when prompted, complete the following steps:
1. When the printer displays AUTHORISED SETUP X, press .
The LCD displays password and the number 0000.
2. Enter the four-digit password for the password level displayed or for a
higher level.
 The left <
←> and right <→> buttons select the digit position.
 The up < ↑> and down <↓> buttons change the selected digit’s value.
3. After entering the password, press .