Argox F1 - Manual (Page 54)

54
Menu System
The menu system lets you set printer options using the buttons on the control
panel. The following is a description of menu selections and settings.
Basic Setup
Press
Note: A checkmark  indicates the default option.
RIBBON This parameter sets print mode for use with
direct thermal (DT) or thermal transfer (TT)
mode. Press the up <
↑> and down <↓>
buttons to scroll through the selection.
YES
This option sets as the printer to TT mode.
NO This option sets as the printer to DT mode.
MEDIA TYPE This parameter shows the type of media you
are using. Press the up < ↑> and down <↓>
buttons to scroll through the selection.
Gap/Notch Select for non-continuous web media,
non-continuous fanfold media, and tags.
GAP LENGTH
10mm (10~99) Selects the gap length of labels.
MARK Non-continuous black mark lines.
MARK
THICKNESS
10mm (10~99)
Select black mark thickness of labels
CONTINUOUS Select for media without gaps or divisions
between labels.
TRANSMISSIVE Select transmissive sensor 1 or 2. Press the
up <↑> and down <↓> buttons to scroll
through the selection.