Argox F1 User Manual
Page 55
55
1 (CENTER)
Sensor 1 is positioned in the center of the
media route. This option enables sensor 1.
2 (LEFT)
The position of sensor 2 is to the left side of
sensor 1. This option enables sensor 2.
MEDIA CAL LENGTH
Set the maximum label length to calibrate.
12 INCH (1~30)
The default media calibration length is 12
inches.
MEDIA CALIBRATION
Calibrate and detect media gap. Press
PRINT MODE
Setup label removal method. The method
you select must correspond to the print
mode. Press the up <
↑> and down <↓>
buttons to scroll through the selection.
NORMAL
TEAR OFF
This parameter establishes the position of
the labels over the tear-off bar after printing.
PEEL OFF
Enables label peeler mode.
CUT
The printer automatically cuts a label after it
is printed.
BY COMMAND
Sets a specific number of labels for cutting by
command.
CUT AFTER
BATCH
The printer waits to cut after the number of
labels you set in BATCH COUNT.
BATCH COUNT
0001 (1~9999)
Sets the number of labels for BATCH CUT.
BATCH CUT
The printer waits to cut after the number of
labels you set
with “P” command to the
printer.
SINGLE CUT
Sets cut after one label