AMETEK XHR 1000 Watt Series - Manual (Page 69)

Remote Operation
Remote Analog Programming of Output Voltage and Current Limit
69
Table 4.1 Power Supply Settings for Different Programming Sources
Output Voltage
Programming
Source Output Current Limit Programming Source
0-5 Vdc 0-10 Vdc 0-5 k Resistor 0-10 k Resistor
None (Front
Panel Control)
0-5 Vdc
SW1: use
default
settings.
J2: jumper
3 to 4, 3 to 5. SW1: set
4 closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
2 closed.
J2 Jumper
3 to 4, 3 to 5. SW1: set
2 and 4 closed.
J2: jumper
3 to 4, 3 to 5. SW1: use
default settings.
J2: jumper
3 to 4.
0-10 Vdc
SW1: set
3 closed:
J2: jumper
3 to 4, 3 to 5. SW1: set
3 and 4 closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
2 and 3 closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
2, 3, and 4
closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
3 closed.
J2: jumper
3 to 4.
0-5 k Resistor
SW1: set
1 closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
1 and 4 closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
1 and 2 closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
1, 2, and 4
closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
1 closed.
J2: jumper
3 to 4.
0-10 k Resistor
SW1: set
1 and 3
closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
1, 3, and 4
closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
1, 2, and 3
closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
1, 2, 3, and 4
closed.
J2: jumper
3 to 4, 3 to 5. SW1: set
1 and 3 closed.
J2: jumper
3 to 4.
None (Front
Panel Control)
SW1: use
default
settings.
J2: jumper
3 to 5. SW1: set
4 closed.
J2: jumper
3 to 5. SW1: set
2 closed.
J2: jumper
3 to 5. SW1: set
2 and 4 closed.
J2: jumper
3 to 5. SW1: use
default settings.
J2: no jumpers