Adtec digital RD-30 (version 2.1.1) Manual - Manual (Page 6)

● The product is equipped with an internal system battery. The product must be sent to Adtec service for replacement of
this battery.
CAUTION – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
● This unit must be installed and serviced by suitably qualified personnel only.
● Do not break the warranty seals on the device or open the lid. Only approved service technicians are permitted to
service this equipment.
● Disconnect all power before servicing the unit.
● Clean only with a dry cloth.
● If not installed in an equipment rack, install the product securely on a stable surface.
● Install the product in a protected location where no on can step or trip over the supply cord, and where the supply cord
will not be damaged.
● If a system is installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than the room ambient temperature.
● Consideration should be given to installing the unit in an environment compatible with the maximum recommended
ambient temperature of 50 degrees Celcius (122 degrees Fahrenheit).
● Install the unit in a rack so that the amount of airflow required for safe operation is not compromised.
○ The recommended clearance on the top and sides of the unit is at least ½ “ (one half inch/one centimeter).
● Mounting of the unit in a rack should be such that no hazardous condition is achieved due to uneven mechanical loading.
● Use only a grounded electrical outlet when connecting the unit to a power source.
● Reliable earth grounding of rack-mount equipment should be maintained.
○ Particular attention should be given to supply connection other than direct connections to the branch circuit (e.g.,
use of power strips).
Compliance Notices
FCC Class A Information
The RD-30 has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment
10.29.14- v2.1.1