Adtec digital RD-30 (version 2.1.1) Manual - Manual (Page 25)

Unicast Reception - Address
To receive a unicast (UDP/RTP/SMPTE2022) stream, place the IP Rx mode to ‘unicast’. The unit will be ‘listening’ for any
streams sent directly to it. Refer to your IP transmitter documentation for proper configuration of the transmitter.
Unicast/Multicast Reception
Enter the port number in the ‘port’ field. The port number must match the port number used on the transmitter where the
range is 1 to 65535. If you are new to multicast and attempting a first time connection, 2000 is a common port to start with.
Lower port numbers are usually reserved for other network services. Please verify transmitter port configuration.
Choose the IP Rx ‘Connector’ dependent upon your network setup. There are two available GigE cards available for receiving
network streams.
Once IP Rx is configured, click Apply.
10.29.14- v2.1.1