Dukane Projector 976SX - Manual (Page 38)

38
Operating
PbyP (Picture by Picture) (continued)
Press any button to select an input port on the remote control or press the
INPUT button on the control panel. A dialog box to select the input signal for
the main area will be displayed. Choose a signal using the ▲/▼ buttons. To
change the signal in the sub area, switch temporarily across to the main area
with the ◄/► buttons.
Displaying the same signal on the both areas is not allowed. Refer to the table
for details on available input signal combinations. Any combinations marked
with "X" can not be selected.
• For some signals, it may not be displayed correctly in the PbyP
mode, even if it can be displayed properly in the normal mode.
NOTE
 Changing the picture input signal
Press the MY BUTTON assigned the
PbyP SWAP (68). The position of the
both area is exchanged without any
setting change.
 PbyP SWAP function
Sub area
Main area
COMPUTER IN1 COMPUTER IN2 LAN USB
TYPE
A
USB
TYPE B
HDMI 1 HDMI 2 COMPONENT S-VIDEO VIDEO
COMPUTER IN1 X O X X X O O O O O
COMPUTER IN2 O X X X X O O O O O
LAN X X X X X X X X X X
USB TYPE A X X X X X X X X X X
USB TYPE B X X X X X X X X X X
HDMI 1 O O X X X X X O O O
HDMI 2 O O X X X X X O O O
COMPONENT O O X X X O O X O O
S-VIDEO O O X X X O O O X O
VIDEO O O X X X O O O O X
main area sub area
main
area
sub
area
main
area
sub
area
• The combined input signals marked with an "O" can be selected
and displayed in the PbyP mode even when the port is set to SKIP with the
SOURCE SKIP on the OPTION menu (65).
NOTE
Input signal