Dukane Projector 976SX - Manual (Page 125)

125
Phenomenon Cases not involving a machine defect
Reference
page
The remote
control does not
work.
The batteries in the remote control are near the end.
Replace the batteries.
17
The ID numbers set in the projector and the remote
control are different.
Press the ID button with the same ID number as the
projector, then perform the desired operation. The ID
number set in the projector can be displayed by pressing
any of the ID buttons on the remote control for 3 seconds
while the lamp is on.
17
Video screen
display freezes.
The FREEZE function is working.
Press FREEZE button to restore the screen to normal.
36
Colors have
a faded- out
appearance,
or color tone is
poor.
Color settings are not correctly adjusted.
Perform picture adjustments by changing the COLOR TEMP,
COLOR and/or TINT settings, using the menu functions.
45
COLOR SPACE setting is not suitable.
Change the COLOR SPACE setting to AUTO, RGB,
SMPTE240, REC709 or REC601.
50
Pictures appear
dark.
The brightness and/or contrast are adjusted to an
extremely low level.
Adjust BRIGHTNESS and/or CONTRAST settings to a
higher level using the menu function.
44
The projector is operating in Eco mode.
Set ECO MODE to NORMAL, and set AUTO ECO
MODE to OFF, in the SETUP menu.
55
8976SX>
If the Projector is used at a temperature over
35°C, the lamp will reduce brightness to protect
components and performance.
Please use the unit within the usage temperature
parameters (0°C to 35°C).
–
The lamp is approaching the end of its product
lifetime.
Replace the lamp.
113, 114
Pictures appear
blurry.
The lens cover is attached.
Remove the lens cover.
4
Either the focus and/or horizontal phase settings are
not properly adjusted.
Adjust the focus using the FOCUS + / - buttons, and/or H
PHASE using the menu function.
29, 49
(continued on next page)
Troubleshooting
Phenomena that may be easy to be mistaken for machine defects (continued)