Xtramus NuStreams-P9M V2.1 - Manual (Page 46)

46
5.3. Starting DUT Tests with NuPAD
NuPAD has 3 buttons on its front panel: “|| Pause”, “■ Stop”, and “ ► Run”. After connecting NuPAD
with NuStreams-P9M with Cat-5 cable, you can start/pause/stop DUT tests with these 3 buttons.
Please see the table down below for a detailed description about these buttons’ functions.
Function Button Description
Start Testing All Tasks
in Current Run
► Run Press “ ► Run” to start all Tasks in
the current Run. The current Run
(Run 1~3) about to be tested will
be displayed on the upper-right
part of LCD.
Switching Current Run || Pause
+
■ Stop
To change the current Run (Run 1~3), press both “|| Pause” and “■
Stop” buttons at the same time. If NuPAD is current in Run 1, pressing
both “|| Pause” and “■Stop” buttons at the same time will switch the
current Run from Run 1 to Run 2.
Pause Current Running
Test
|| Pause Press “|| Pause” button once to pause the current running test. Press “||
Pause” button again to resume the test.
Stop Current Running
Test
■ Stop Press “■Stop” button once to stop the current running test.
XTRAMUS TECHNOLOGIES
®
E-mail: [email protected]
Website: www.Xtramus.com