Xtramus NuApps-MultiUnits-RM Ver1.5 - Manual (Page 49)

5. NuApps-MultiUnits-RM Detail Task Setting
As mentioned in “4.2.4. Configuring Tasks Listed on List of Selected Tasks”, you can make detail
settings with individual tasks by clicking the task you would like to configure from List of Selected Tasks.
All the configurations for this task will be listed in the right-side section as shown in the figure down below.
All tasks available for NuApps-MultiUnits-RM can be divided into different groups Unicast, Flow Control,
Broadcast, Filter tasks and CRC error. Please refer to “1.2. Function Description_ Performance Task
in Layer 2 (PT2 ) ” for descriptions. Also, descriptions for each task can be viewed on
NuApps-MultiUnits-RM as well.
49
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®