Tempest Cyclone - Manual (Page 42)

Cyclone Enclosure User Manual
page 42
6 Closing up the Enclosure
1 Check all electrical connections
2 Clear the enclosure and projector of all dust
and debris.
3 Check that the power switch on the projector
is in the ON position.
4 Complete all signal connections, following
projector manufacturer’s instructions.
5 Test projector
6 Tie down cables so that they will not touch
heaters or fans.
7 Replace the cover on the Blizzard base. This
may require two people.
Congratulations! Your system is now ready for use.

 