Rdm monitoring and configuration – Tempest Cyclone User Manual
Page 35
Cyclone Enclosure User Manual
page 35
e) Current being drawn by projector/light, in Amps
f) Lamp Hours elapsed since last reset
g) Firmware version
RDM Monitoring and Configuration
All the features accessible over the DEC3.3 control panel are also available over RDM. Just how
this information is displayed will depend on the RDM interface used. These screen shots were
taken running the GetSet program in Windows 7, and connecting to a DEC3.3 controller using a
RDM TRI MK1 interface, Tempest part # 2000.190
This view shows a single
DEC3.2 test unit that has been
correctly discovered and
labeled by the GetSet software
suite, and a log of RDM
messages.
This RDM interface provides a
graphic view of the various
sensor functions supported by
DEC3.2 and up
Important:
Check that your RDM interface
vendor has tested his interface
with Tempest enclosures and
all other RDM devices you plan
to use on the same network.