Tempest Cyclone - Manual (Page 38)

Cyclone Enclosure User Manual
page 38
b. For projectors without threaded sockets on the underside, clamps are provided to secure
the projector feet to the projector tray, to prevent movement.
c. Portrait enclosures have a vertical mounting frame. The projector generally bolts to the
frame.
3. Release the two projector tray slide bolts and fully extend the tray.
4. Set the projector on the tray and check for center. The projector should be centered and
mounted with the front of the lens above the end of the tray.
a. Portrait Enclosures: Bolt the projector to the vertical projector mount, using the bolts
provided. You can still adjust the feet, but this will require more people to:
i. Support the weight of the projector
ii. Loosen/tighten mounting bolts
iii. Lower/raise projector feet
Portrait Projector
Mounting Frame
mounts on
projector tray
Projector Bolt, flat
washer, spring washer.
Type and quantity vary
by projector.
Projector Tray
Slide Bolt (x 2)
Projector Foot Clamp
slides over feet and
bolts to tray front
and back.