Mounting – Tempest Cyclone User Manual
Page 10
Cyclone Enclosure User Manual
page 10
Mounting
The Cyclone enclosure is provided with a pair of stainless steel Unistrut channels on the enclosure
base, for mounting to your structure. You may use standard Unistrut accessories, or purchase
mounting kits from Tempest Lighting – four kits are required per enclosure.
Each Enclosure must be mounted with FOUR points.
8400 and up must be mounted with SIX points when suspended from a structure.
All mountings must be made using the two Unistrut channels on the base of the enclosure.
Tempest Lighting recommends the use of stainless steel mounting hardware.
IMPORTANT SAFETY NOTICE:
Installer must ensure that all mounting points are secure and conform to local safety
regulations. Tempest Lighting Inc. accepts no responsibility for damage or injury arising
from inappropriate or unsafe installation.
These mounting accessories are available from Tempest:
4900.MB
Stainless Steel Unistrut channel nut, bolt and
washer. Four required per enclosure (6 when
suspending Cyclone 8400 and up)
4900.MC
Stainless Steel Unistrut channel nut, bolt and
pipe clamp, for pipes 1.5” (38mm) to 2” (50mm) OD.
Four required per enclosure (6 when suspending
Cyclone 8400 and up)
.
4925.MC
Stainless Steel Unistrut channel nut, bolt and
pipe clamp, for pipes 2” (50mm) to 2.5” (64mm) OD.
Four required per enclosure (6 when suspending
Cyclone 8400 and up)
.