Christie roadie hd35k projectors – Tempest Cyclone User Manual
Page 41
Cyclone Enclosure User Manual
page 41
Christie Roadie HD35K Projectors
These projectors (mounted in Cyclone 8400 enclosures) use an external DC ballast to supply power to
the projector lamp, over two 200 Amp single pole cables, with CamLok type single pole connectors.
Christie specifies a cable run between ballast and projector of up to 100’/30m.
1. Cyclone 8400 Enclosures supplied for use with these projectors include two CamLok panel
receptacles on the rear door, and internal DC wiring to the back of the projector. The cable
loop inside the enclosure is approximately 10’/3m, so the maximum permissible cable length
from the ballast to the outside is therefore reduced to 90’/27m.
2. When the projector is placed on the projector tray, connect the DC cables to the receptacles at
the back of the projector BEFORE fixing the projector is in place.
3. Make sure that both Camlok plugs are fully inserted, and twisted ¼ turn clockwise.
4. Set the projector in position, and feed any cable slack back through the cable track, before
fixing the projector in place.