NEXCOM MRC 2200 User Manual

Page 38

Chapter 3: Operating Your Tablet PC

MRC 2200 User Manual

To connect to a wireless network:
1. Double-click the Wireless Network Connection icon located at bottom
right on your Windows system tray.
2.The Wireless Network Connection window displays the detected wireless
network.

3. Choose

a wireless network to connect, click , and follow the Windows
instruction to complete the network setup.

4. If you are connecting to a protected network, enter the security info
when prompted.

Using the Bluetooth Wireless Feature

You may use the build-in Bluetooth feature for short-range wireless com-
munications between devices up to 10 meters. The default setting of the
Bluetooth feature is active (always ON) upon booting your tablet PC; and it
is in the general discoverable and pair-able mode.

Adding a device- Steps to take on the MRC 2200
1. From Desktop, go to Start > Run, type bthprops.cpl, and then click
.
2. In Bluetooth Settings, click .
3. In the Add Bluetooth Device Wizard, click to select the “My device is set
up and ready to be found” check box, and then click .
4. Select a device to add, and then click .
5. Enter a passkey for the device.

Adding a device- Steps to take on the device
1. On the connecting device, click in the message that indicates that you
are requesting a connection.
2. Enter the same passkey as entered in step 5.

When the passkey is verified, the connection is complete. The device is
now visible on your computer. By default, the option to turn discovery off
is selected so that the computer does not remain discoverable at all times.
Refer to Windows Help for more detail.