Hapter, Etup, Tility – NEXCOM NEX 611 User Manual

Page 37: 1 introduction

Chapter 3: Uefi Setup Utility

NEX 611 User Manual

haPter

3: u

efI

etuP

tIlIty

3.1 Introduction

This section explains how to use the UEFI Setup Utility to configure your
system. The UEFI chip on the motherboard stores the UEFI Setup Utility.
You may run the UEFI Setup Utility when you start up the computer. Please
press or during the Power-On-Self-Test (POST) to enter the
UEFI Setup Utility, otherwise, POST will continue with its test routines.
If you wish to enter the UEFI Setup Utility after POST, restart the system by
pressing + + , or by pressing the reset button on the
system chassis. You may also restart by turning the system off and then
back on.

3.1.1 UEFI Menu Bar

The top of the screen has a menu bar with the following selections:
Main

To set up the system time/date information

Advanced

To set up the advanced UEFI features

H/W Monitor To display current hardware status
Boot

To set up the default system device to locate and load

the Operating System
Security

To set up the security features

Exit

To exit the current screen or the UEFI SETUP UTILITY

Use < > key or < > key to choose among the selections on the menu
bar, and then press to get into the sub screen. You can also use
the mouse to click your required item.

Because the UEFI software is constantly being updated, the
following UEFI setup screens and descriptions are for reference
purpose only, and they may not exactly match what you see on
your screen.