NEXCOM NEX 611 User Manual

Page 32

Text mode
Original mode

Chapter 2: Installation

NEX 611 User Manual

2.8.3 Installing Windows

8/ 8 64-bit/ 7/ 7 64-bit/

VistaTM/ VistaTM 64-bit with RAID

RAID mode is not supported under Windows

XP.

STEP 1: Set Up UEFI.
Press or at system POST. Set RAID Mode in UEFI Setup
Utility > Advanced > Storage Configuration > SATA Mode.

STEP 2: Use “RAID Installation Guide” to set the RAID configuration.
Before you start to configure RAID, you need to check the installa-
tion guide in the Support CD for proper configuration. Please refer
to the document in the Support CD, “Guide to SATA Hard Disks
Installation and RAID Configuration”, which is located in the folder
at the following path:
.. \ RAID Installation Guide

STEP 3: Install Windows

8/ 8 64-bit/ 7/ 7 64-bit/ VistaTM/ VistaTM

64-bit on your system.