NEXCOM NEX 611 - Manual (Page 34)

Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 23
Chapter 2: Installation
NEX 611 User Manual
SATA
7-pin
connector The 1x4-pin
conventional power
connector (White)
should be connected
to a power supply The SATA 15-pin power
connector (Black) should
be connected to your
SATA3 HDD
A. SATA data cable (Red) B. SATA power cable
2.10 Hot Plug and Hot Swap for Hard
Disk Drives
This motherboard supports Hot Plug and Hot Swap for SATA3 in AHCI /
RAID mode. (Raid is not supported by AMD A50M) Hot Plug / Hot Swap Operation Guide
Please read the operation guide of Hot Plug / Hot Swap below carefully.
Before you process Hot Plug / Hot Swap, please check the cable accessories
from the motherboard gift box pack below.
A. 7-pin SATA data cable
B. SATA power cable with SATA 15-pin power connector interface
What is Hot Plug and Hot Swap?
If the HDDs are NOT set for RAID, it is called “Hot Plug” for the
action to insert and remove the HDDs while the system is still
powered on and in working condition. If the HDDs are set for
RAID then it is called “Hot Swap”. However, please note that
it cannot perform Hot Plug or Hot Swap if the OS has been
installed into the HDD.