NEXCOM NEX 611 User Manual

Page 29

Chapter 2: Installation

NEX 611 User Manual

Clear CMOS Jumper

Jumper

Setting

(3-pinCLRCMOS1)
(see p.10, No.27)

Default Clear CMOS

2.7 Expansion Slots
(PCI, PCI Express and mini-PCIe Slots)

There are 2 PCI slots, 2 PCI Express slots and 1 mini-PCIe slot on this moth-
erboard.

PCI slots: PCI slots are used to install expansion cards that have the 32-bit

CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the sys-
tem parameters to default setup, please turn off the computer and unplug
the power cord from the power supply. After waiting for 15 seconds, use a
jumper cap to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However,
please do not clear the CMOS right after you update the BIOS. If you need
to clear the CMOS when you just finish updating the BIOS, you must boot
up the system first, and then shut it down before you do the clear-CMOS
action. Please be noted that the password, date, time, user default profile,
1394 GUID and MAC address will be cleared only if the CMOS battery is
removed.