Dan Dugan Sound Design E-2 - Manual (Page 21)

Dugan Model E-2 User Guide Installation and Configuration
21
Digital
Move the ANA-DIGI switch to the DIGI (down) position. This switches the I/O to the
ADAT connectors.
The state of the #ch switch determines the I/O count and linking capability. This can
be set in the Dugan Control Panel (see Chapter 4: Dugan Control Panel) or with a pow-
er-up command (see Appendix A: Power-up Commands).
8-Ch
• Channels 1–8 on AUD IN/AUD OUT
• Linking and Music System available
The Music System threshold inputs are still input as analog signals on AUDIO I/O 9–
12
(channels 9–11).
• Mix bus outputs available on AUDIO I/O 9–12 (channels 9–12)
• Unprocessed outputs are available on AUDIO I/O 1–4 and AUDIO I/O 5–8
16-Ch
• Channels 1–8 on AUD IN/AUD OUT
• Channels 9–16 on LINK IN/LINK OUT
• Dugan Music System, input splits, mix bus outputs, and linking not supported
Music System Threshold Inputs
A Music System threshold signal can be provided as a reference for each group. When
the levels of channels in the group exceed the level of the Music System threshold
signal, the channels come up to full gain.
The sensing mics are typically input to the same console as the program mics, but are
routed to direct outputs or sends, not mix buses.
The AUDIO I/O 9–12 DB25 connector can receive three Music System threshold inputs,
one for each group (a, b, c on channels 9, 10, 11).