Power supply, System reset – Dan Dugan Sound Design E-2 User Manual
Page 18
Dugan Model E-2 User Guide
18
Power Supply
Units shipped to the USA include a 12 V, 1.5 A, 120 VAC power supply. Contact the
factory if you require a different power supply. In an emergency, the Model E-2 can
accept power supplies within the following ranges:
•
12–24 VDC, either polarity, 1.5 A
•
9–18 VAC, 1.5 A
System Reset
Hold down the channel 1
bypass
button and power up the unit. Keep holding the
by-
pass
button down for about three seconds until the unit finishes booting.
This System Reset command restores all parameters to factory default settings and
clears label text. This is just like zeroing a console before a show. We recommend ex-
ecuting a System Reset before starting a new installation.
The Model E-2 can execute four other power-up commands (see Appendix A: Power-
up Commands).
NOTE:
If for any reason you cannot connect to a computer, power-up commands can establish
essential settings.