d&b T-Series - Manual (Page 30)

7. Derig the array
WARNING!
Dismantling the assembly of 4 x T10 cabinets while releasing
the Splay link of the upper cabinet and lower the assembly the
entire array could move or swing towards the front in a
sudden.
Therefore we strongly recommend you to proceed as follows:
- Ensure no other person remains in the vicinity of the
assembly area.
- Always secure the array by a second person to safely lower
the array and dismantle it.
- Lower the array to a suitable working height.
- On the rear lift the bottom assembly until the second Locking pin
(securing pin) of the Splay link can be released.
- Lift the assembly further more until the Splay link can be hooked off.
- Carefully lower the assembly while a second person renders support
to secure the entire array against uncontrolled movement and swing.
- Place the bottom tray of the E7451 Touring case below the array.
- Release all safety pins (second Locking pin) at the rear of the bottom
four cabinets before lower them into tray of the case.
- Lower the assembly into the tray while a second person renders
support to secure the case against uncontrolled movement or tipping
over.
- Before releasing the two Locking pins of the Front links which connect
the bottom assembly with the array, a second person renders
support to secure the entire array against uncontrolled movement
and swing.
- Release the Locking pins of the Front links and lift the array slightly.
- Release all Locking pins on the rear rigging strand and fold down the
Splay links so that the cabinets are on block.
- Proceed in the same manner until the array is completely dismantled.
T-Series Rigging manual (1.1 EN) Page 30 of 44