d&b T-Series - Manual (Page 27)

4.1.4. Setup of the E7451 Touring case assembly
E7451 Touring case 4 x T10 assembly
WARNING!
The total center of gravity of the E7451 Touring case assembly
will shift towards the front during assembly.
To prevent the case from moving and tipping over during setup
and/or dismantling we strongly recommend you to proceed as
follows:
- Carry out the setup with two persons with one person
securing the case.
- Ensure no other person remains in the vicinity of the
assembly area.
Preparations
- Prepare the flying cables and link cables according to the number of
amplifier channels and cabinets used.
Order of assembly
1. Suspend the Flying frame
- Suspend the Flying frame according to the chosen type of suspension
as described in section 3.3 on page 15.
- Release the two Locking pins at the front of the frame.
2. Prepare the T10 cabinets in the touring case
- Bring the Touring case into position.
- Slide out the Front links of the upper cabinet.
- Set the splay angles between the cabinets according to your
ArrayCalc simulation as follows:
- Starting with the top cabinet of the assembly first preset the
desired splay angle by inserting one Locking pin.
- Fold up the Splay link of the cabinet below into the rear
rigging strand of the upper cabinet.
- Lift the upper cabinet by hand until the hook of the Splay
link has hooked into the preset Locking pin.
- Insert the second Locking pin (safety pin) to secure the Splay
link.
- Proceed in the same manner until all splay angles of the assembly
are set.
T-Series Rigging manual (1.1 EN) Page 27 of 44