d&b T-Series - Manual (Page 20)

4.1. Flown arrays
4.1.1. T10 Array
Limitation
A maximum of 20 x T10 cabinets are allowed to be flown.
Preparations
- Prepare the flying cables and link cables according to the number of
amplifier channels and cabinets used.
- Ensure the HF sections of the T10 cabinets to be used are set to Line
source.
Order of assembly
1. Suspend the Flying frame
- Suspend the Flying frame according to the chosen type of suspension
as described in section 3.3 on page 15.
- Release the two Locking pins at the front of the frame.
2. Prepare the first T10 cabinet
- Prepare the Front and Splay links of the first T10 cabinet as
described in section 2.4 on page 11.
3. Attach the Flying frame to the first T10 cabinet
- Lower the frame onto the cabinet until the Front links fit into the slots
at the front of the frame.
- Insert and lock the frame's Locking pins through the Front links of the
T10 cabinet on both sides.
- Release the upper Locking pin at the support point for the Splay link
on the center bar of the frame.
- Fold up the Splay link of the cabinet into the track of the frame's
center bar until the link hooks over the Locking pin.
To achieve this you may first have to lower the frame slightly more.
- Lift the frame by hand until the Splay link hooks into the Locking pin
and keep holding the frame in this position.
- Insert the second Locking pin (safety pin) to secure the Splay link.
- Lift the frame to a suitable working height to add the next cabinet.
T-Series Rigging manual (1.1 EN) Page 20 of 44