CRU Ditto Forensic FieldStation User Manual

Page 35

Protecting Your Digital Assets

Ditto Forensic FieldStation User Manual

c. Under the “iSCSI Source Connections” or the “iSCSI Destination Connections” section, check the

boxes next to the IQN(s) you want to remove and click the

Remove button

d. Physically disconnect the iSCSI device from the Ditto Forensic FieldStation.

11.4 USING NFS AND SMB (SAMBA) SHARES

11.4.1 Connect to NFS and SMB Shares

a. On the “Home” Screen, navigate down to the bottom of the “Disks” panel.

b. Click the

Source Network button

if the Ditto Forensic FieldStation is connected to your network via

the source Ethernet Port, or click the

Destination Network button

if it is connected via the destina-

tion Ethernet Port.

c. Click on the

NFS tab

or the

SMB tab

, depending on which type of share you are connecting to.

d. Type the server name into the Server text field.

e. If you are connecting to an SMB share, select the appropriate protocol from the “Protocol” drop-down

box. If you don’t know the correct protocol, leave it as the default value of ‘SMBv1’.

f. Click the

Show Shares button

. The Ditto Forensic FieldStation will detect any shares attached to the

server.

g. Select the share you wish to attach to the Ditto Forensic FieldStation from the drop-down box.

h. If you are connecting to an SMB share and authentication is required, click the

Advanced... button

and input the appropriate credentials, including the user name, password, and domain. If the SMB
share does not require authentication or you are connecting to an NFS share, continue to the next
step.

i. Click the

Add button

. The share will now appear in the list below.

j. Repeat steps C through I to add more shares. When you are finished, click

Close

The share(s) have now been added to the list of Disks, allowing you to perform actions on them like you
would any other disk.

11.4.2 Remove an NFS or SMB (Samba) Share