beautypg.com

CRU DE110 SATA 3G User Manual

De110 sata 3gb/s install guide, Rugged, reliable, mobile, secure

background image

Rugged, Reliable, Mobile, Secure

TM

1-800-260-9800

www.CRU-DataPort.com

DE110 SATA 3Gb/s Install Guide

Removable SATA 3Gb/s Drive Enclosure

Receiving Frame Motherboard

I/O Connector (JP1)

The input/output connector provides a standard interface for all

SATA signals.

SATA Power Connector (P1)

15-Pin SATA power connector to accept DC power.

NOTE: If your system does not accommodate the SATA

power connector, use a SATA-to-DC Power adapter cable

(sold separately) to connect to your system’s DC power.

Drive Activity LED Pin (JACT1)

Pin 1 is used for host connection (cable not included) to the Drive

Activity LED. Some SATA PC systems/host controllers provide

support for the Drive Activity LED feature (refer to the SATA PC

system/host controller manufacturer’s documentation for further

information).

Factory Reserved Pins

These pins are reserved for factory use only - Do not install

jumper under any circumstances!

Figure 2: Drive Installation Assembly

Installation

1. Remove the drive cover from the carrier.

2. Carefully insert the drive into the carrier. Slide the drive

towards the Drive Carrier Board, so that the I/O connector on

the drive mates with the connector on the Drive Carrier Board.

Turn the drive/carrier assembly over.

3. Fasten the drive into place with four (4) #6-32 Phillips Flat

Head screws. Some drives may require minor adjustment

before securing into carrier with screws.

4. Install the drive cover and secure with two (2) #6-32 Phillips

Flat Head screws (provided).

Figure 1: Receiving Frame Motherboard (rear view)

Drive Activity

LED Pin

Reserved

SATA Power

Connector

(P1)

I/O Connector

(J1)

= Pin 1

SATA Drive

(not included)

Drive Carrier

Drive Carrier

Board

#6-32 Phillips

Flat Head Screw

(4 each)

NOTE:

DE110 SATA 3Gb/s receiving frames support both SATA 3Gb/s

and DE110 SATA 3Gb/s carriers.
DE110 SATA 1.5Gb/s “universal’ receiving frames support

DE110 SATA 1.5Gb/s and DE110 PATA carriers.
For SATA 3Gb/s operation, a SATA 3Gb/s controller and SATA

3Gb/s drive are required.