CRU Ditto Forensic FieldStation - Manual (Page 28)

28
Protecting Your Digital Assets TM
Ditto Forensic FieldStation User Manual
9.3 DISK INFO
The “Disk Info” screen shows all available disks attached to either the source or desti-
nation ports. Ports are shown only if a disk is connected there. Press
Enter (View) and
then Up or Down to scroll through the following information about each connected disk:
• Model number
• Disk capacity
• File system
9.4 PERFORM ACTION
After you adjust settings to your specifications, you are ready to put the Ditto Forensic FieldStation to work.
The “Perform Action” screen lets you start or abort any of the Ditto Forensic FieldStation’s actions using the
current settings.
j. On the “Perform Action” screen, use the Up and Down buttons to cycle through the available actions.
Press Enter to select the one you want.
k. Cycle through the available settings for the action. Press Enter if you wish to modify them.
l. When you are finished modifying settings, scroll down to option that asks you to start the action (ex.
“Start Physical Image?”. Press Enter to begin.
The status and remaining time will be displayed on the LCD screen as the Ditto Forensic FieldStation per-
forms the action. To abort an action, press the
Back button. The LCD screen will ask if you wish to abort the
action. Press Enter to confirm, or Back to cancel the abort request.
9.5 FACTORY RESET
To reset the Ditto Forensic FieldStation’s settings back to their factory defaults, press
and hold the
Up , Enter , and Down navigation buttons while powering the unit on. The
Ditto Forensic FieldStation will start up and then display the text, “Preparing Factory
Reset” (see Figure 27).
You will then be prompted to confirm your choice to reset the Ditto. Press Enter to
continue or Back to cancel.
You can also use the browser interface to perform a factory reset. See Section 8.1.3.
10 STEALTH MODE
Stealth Mode turns off all LEDs and LCDs on the Ditto Forensic FieldStation. You can enable Stealth Mode by
flipping the physical “Stealth Mode” switch on the Destination Outputs side of the Ditto Forensic FieldStation
(see Section 1.2).
You can also enable it from the browser interface. Click on the Configure tab , and then under the “System” tab
change the “Stealth Mode” drop-down box to “Enabled.” Then click Commit Changes .
If Stealth Mode is enabled from the browser interface, the physical switch cannot override it.
****DITTO****
Initializing...
Preparing Factory Reset
Figure 27. The “Preparing Factory Reset” screen on
the Front Panel LCD.
Source eSATA:
HTS5410806XXXXX
79.8GB
No file system
Figure 26. The “Disk Info” screen on the Front Panel
LCD.
NOTE