Stop – CRU Ditto Forensic FieldStation User Manual
Page 17
17
Protecting Your Digital Assets
TM
Ditto Forensic FieldStation User Manual
DHCP End Address:
10.10.10.199
DNS Server:
Enabled
DNS Domain Name:
ditto.local
NTP Server:
Enabled
NAT Gateway:
Disabled
Do not connect the Ditto Forensic FieldStation to another network while it is configured as a server.
Doing so will cause network conflicts and may disrupt network traffic.
Client (DHCP)
This option automatically configures the destination Ethernet port to connect to the attached network.
Client (Static IP)
This option allows you to manually configure the destination Ethernet port to connect to the attached
network.
5.3 CLONE
The “Clone” tab allows you to view and customize the following settings for disk cloning actions, including
the “Clone & Image Source Disk” action. When you are finished, click the
Commit Changes
button to save
the changes.
5.3.1 Typical Settings
•
Source HPA/DCO:
Sets whether the cloning action should indicate in the log that there is an HPA
(host protected area) or DCO (device configuration overlay) present, temporarily bypass the HPA,
permanently unhide the HPA, or permanently unhide both the HPA and DCO.
•
Fill to End of Disk:
Check this box to enable zeroes to be written to the end of the disk.
•
Reset HPA After Fill:
Sets the HPA on the destination disk so that the capacity of the destination
disk is identical to the capacity on the source disk.
5.3.2 Advanced Settings
The advanced settings may be hidden. Click the Show button to reveal them.
•
Buffer Size:
Sets the the buffer size used by the Ditto Forensic FieldStation during a cloning action.
The minimum size is 512K (kilobytes). The default size of 1M (megabyte) works best for most uses.
The maximum size is limited by the target file system.
•
Exit when a bad sector is encountered:
Aborts the cloning action if the Ditto Forensic FieldStation
encounters a bad sector on the source disk.
5.4 PHYSICAL IMAGE
The “Physical Image” tab allows you to view and customize the following settings for physical imaging
actions, including the “Clone & Image Source Disk” action. There are separate options available for both
the “E01” and “DD” image types. When you are finished, click the
Commit Changes
button to save the
changes.
STOP!